Amica OKF621G EN User Manual download pdf (Page 7)

INSTALLATION

Installation of the ventilation hood in the exhaust mode

(extracting of used air to the outside)

1.Fixthewallsectionoftheventilationhoodtothewall,usingxingpinsandscrews

from the installation packet, at a height so that the suspended ventilation hood in on

the level of 650-750 mm over the top of the stove.

2.Removethefatlteroftheventilationhood(thenumberoflters

depends on the type of the hood) by unfastening the snap fastener.

3. The hood must be placed with its installation opening in the back

against the wall over the installed wall section so that the upper edge of

the opening slides into the wall section (see the drawing beside).

4. The ventilation hood should then be leveled using a hand level and, if necessary,

its position should be corrected by screwing in or out of the leveling screws located

on the body of the hood over the installation opening. After the ventilation hood is

leveled, a securing screw should be screwed in in the middle of the wall section.

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

No comments

Amica OKF621G EN User Manual Page 7